-1-PKI-00042000 Series Owner s ManualThank you for purchasing PIAA product. To ensure the product functions properly please read the manual
-10-PKI-0004Connect the bulb s lead wire to the harness for the (+) terminal. Make sure the sleeve completely covers the terminal.Sleeve(-) Harness (
-11-PKI-0004Verify each section according to the following. 1 After installation, if the lamp does not activate → Check the wiring and make s
-12-PKI-0004【8】PIAA LIMITED WARRANTYWith the exception of bulbs, PIAA Corporation, USA ("PIAA") warrants its products to be free from defect
-2-PKI-0004● This lamp is a hanging type and uses a bracket. If using it upright, set the bracket up correctly so that the PIAA logo is properly dis
-3-PKI-0004※ Please use the tools indicated below.● Philip s head driver※ Verify that all the parts are included. If a part is missing, please contac
-4-PKI-0004【1】Preparation for InstallationThe entire face of the double-sided tape can be placed on a flat surface.Apply double-sided tape.Where should
-5-PKI-0004BracketDouble-side tape(Item 3)Hexagon Bolt● Make sure the lamp can be adjusted up and down (beam must be adjusted so that it shines at le
-6-PKI-0004The numbers shown in the figure below indicate the sequence the parts should be installed.Remove the (-) termi-nal from the battery.Remove t
-7-PKI-0004Temporarily set the bracket with masking tape and then mark the correct position.Remove the lamp harness and take out the lamp.◆ If using o
-8-PKI-0004【4】Fog Light AimingThere are two important issues to address when installing fog lights, the first is to minimize the amount of return glare
-9-PKI-0004Loosen the 4 screws on the back of the lamp housing. Re-move the lens unit from the housing unit.● After replacing the lamp and reassembli
Kommentare zu diesen Handbüchern